BLOXYGEN FINISH PRESERVER
Click Above, for the can label and more information
Bloxygen Finish Preserver for Unused Finishing Materials
STOP throwing away partially used oil paints and varnishes - Use Bloxygen
 Bloxygen uses ultra pure Argon, the natural inert gas
drives the oxygen and moisture from the container.
Simply blow the oxygen out of the container with Bloxygen,
then seal the lid.
The heavy, inert Bloxygen gas sinks down and blocks oxygen
from the liquid surface. Because Bloxygen is heavier than air,
it will seal the liquid from any air that may remain in the container.
• Recommended for oil / solvent based products.
• Up to 75 uses per aerosol. • NOT for use with latex or lacquer products.
• Non-flammable • Non-toxic • Contains argon
Is BLOXYGEN expensive?
It Is NOT expensive, BLOXYGEN lasts for about 75 uses for quart cans.
If you save just one half of a $24 quart of varnish, you've paid for your BLOXYGEN.
The next 74 uses are "free!"
|
|
|
Wiping WOOD STAIN UPS Only
Click Above for application information
WIPING WOOD STAIN - The same formula previously labeled H.BEHLEN 15 Min Stain
 Mohawk Pigmented Wiping Wood Stains are semi-transparent, pigmented,
solvent-based stains that are non-grain raising, fade resistant, easy to stir,
soft-settling formulas. Allow 30 minutes drying time before a lacquer
sealer or topcoat can be sprayed. Apply by spray, brush or cloth.
Pigmented Wiping Stains are easier to control because there's less lapping.
An ideal uniforming stain when applied over NGR Dye stains prior to sealing.
A dark color tone may be lightened with use of Wood Stain Reducer S-15.
This stain will not bleed through the finish. Virtually any finish can be applied
over Wiping Wood™ Stain: lacquer, shellac, varnish, polyurethane,
acrylics and many others.
Fall/Winter Sale: Limited To Stock On Hand
Note: Maintain the working characteristics of the stains by using the M545-0106 - Stain Base
to lighten or extend the stain color. Avoid thinning Wiping Wood Stains with solvents.
One Quart - Also Available In Gallons (Please Phone for gallon orders)
Ex. Dark Walnut
M545-2096
|
Med Brown Walnut
M545-2076
|
Medium Walnut
M545-02056
|
Burnt Umber
M545-14356
|
Raw Umber
M545-01436
|
Black
M545-2246
|
Natural
M545-0026
|
Light Golden Oak
M545-4156
|
Dark Golden Oak
M545-2206
|
Jacobean (Oak)
M545-10046
|
Weathered Oak
M545-10036
|
Shale Grey
M545-10016
|
Dk Red Mahogany
M545-2276
|
Brown Mahogany
M545-2296
|
Perfect Brown
M545-2496
|
Brown Maple
M545-2366
|
Cherry
M545-4086
|
Antique White
M545-4126
|
Note:The Pure WHITE # M545 -2026 is not shown on the above color guide
|
DESIGNER Series STAINS UPS Ground Only
Click above for data & application information
DESIGNER Series STAINS
Mohawk Designer Series Stains are unique Dye with Stain colors
that enable deep, rich, intense color development in one application
that previously may have taken multiple color steps to achieve.
These rich Dye / Stain formulations can be sealed
in as little as 30 minutes under good drying conditions.
Designer Series products may be blended together to create custom colors.
Note: Colors are approximate representations of actual colors using modern process techniques.
Color Guide variations (due to printing processes & display screens) may occur.
|
Finisher's SHADING GLAZING STAINS UPS Ground Only
Important: Click above for Application Information
Mohawk SHADING & GLAZING STAIN
 FINISHERS GLAZE™ SHADING & GLAZING STAINS are
a special blend of concentrated colorants and topcoat friendly resins
(to ensure good adhesion between sealing and finishing coats)
in a medium viscosity base.
The formula allows the finisher to create unique toning
and highlight effects over almost any sealed surface.
Compatible for use with conventional and modern catalyzed finishes
as well as conversion varnishes and urethanes.
Use on a sealed surface, when using as a glaze.
View or Print PDF Glaze Application Informaton
Concentrate colors are shown for comparison only, color rendering subject to computer monitor limitations.
 Raw Umber
M504-01436
|
 Burnt Umber
M504-14356
|
 Black
M504-2246
|
 Raw Sienna
M504-4776
|
 Burnt Sienna
M504-4766
|
 Van Dyck Brown
M504-14786
|
 Dk Rd Mahogany
M504-2276 |
|
HEAVY BODIED GLAZES UPS Ground Only
Important: Click above for Application Information
Heavy Bodied GLAZE
 Mohawk Heavy Bodied Glazing Stains have a creamy texture for better control and easier application without dripping or running. Heavy Bodied Glazes are manufactured from the finest refined non-break Linseed Oil and micronized pigment colors.
Heavy Bodied Glazes are excellent for special effects:
1. Highlights. 2. Grain
3. Color contrast 4. Antiquing
5. Frosting 6. Splatter or distressed appearance
7. Marbleized texture
8. Metallic effects with the addition of small amounts of bronzing powders
Note: Glaze must be top-coated within 6 hours of application to insure lifting will not occur.
CAUTION: Rags or other materials containing this product may oxidize and ignite.
To avoid spontaneous combustion, All contaminated materials should be immersed in water immediately after use.
View or Print: HEAVY BODIED GLAZE Data Sheet
|
General Finishes OIL BASED Wipe-On GEL STAINS
Click Above for Data & Application Information
Oil Based Wipe-On GEL STAINS
See: General Finishes GEL STAIN Brochure
General Finishes Oil Gel Stains are heavy-bodied and do not
penetrate as deeply into the wood as liquid oil based stains do.
Oil Gel Stains provide the richest colors of any oil based stain available.
"General Finishes make the professional standard in Gel Stains."
The popular color Java Gel Stain (Dark Roast Coffee color) has been featured
in social media for upcycling and refurbishing of furniture and cabinets.
Colors: Golden Pine, New Pine, Prairie Wheat, American Oak, Colonial Maple,
Candelite, Nutmeg, Antique Walnut, Brown Mahogany, Georgian Cherry, Java, Gray, Black
Digitized colors shown are for reference purposes only.
Always test stain on a piece of the same wood or a hidden area of the project to verify your desired color.
|
Oil Based Liquid Wipe-On Penetrating WOOD STAINS
Click Above for Data & Application Information
OIL Based PIGMENTED WIPING STAIN
General Finishes Liquid Penetrating Wipe or Brush on Pigmented Wood Stains
have been the professional finishers favorite for over 50 years.
General Finishes Oil Based Wood Stains are made from the highest quality oils.
This traditional pigmented wiping stain has good predictable working characteristics.
A traditional formulation for use on raw wood (new or stripped).
Blend stains and Natural Stain Base to make additional colors, tints, or shades.
To make Custom Colors, add the stains, UTC or oil colorants to the Natural Stain Base.
Colors:
Natural -- Pre-Stain Conditioner / Stain Base
Honey, Honey Maple, Pecan, Salem, Danish Teak, American Walnut,
Antique Cherry, Candlelight, Warm Cherry, Mahogany, Spiced Walnut
|
General Finishes Water Based WOOD STAINS
Click Above for Data & Application Information
Water Based Pigmented Wiping WOOD STAINS
GENERAL FINISHES Water Based Wood Stains have all the
advantages of oil based stains: they spread easily, can be repaired,
blend effortlessly and have plenty of open working time.
The thicker formula allows controlled penetration, which will reduce blotching
on softer woods such as Aspen, Pine, and Soft Maples.
• For Interior applications Only. • Apply by brush or spray.
Available: Pints, Quarts, (& on order Gallons)
Colors:
Natural, Country Pine, Antique Oak, Pecan,
Black Cherry, Walnut, Brown Mahogany, Espresso Not Pictured: Weathered Gray, Black
Closeout Clearance SALE -- Stock on Hand Only
|
|
M547-54046
